Inspection items of organic fertilizer crusher machine before production

Date:2020/10/28

In general, the factory has a test run before the organic fertilizer machine leaves the factory. Here to remind you of a few points, before the organic fertilizer crusher is transported to the production site to start production, we must test the machine again empty.

Inspection items of organic fertilizer crusher before production

1. Tighten the bolts on the equipment first, which is very necessary to avoid big mistakes caused by small mistakes.

2. Does the organic fertilizer grinder vibrate? If there is vibration, first check whether the installation base is not on a horizontal plane. If this is negative, then judge from the inside of the equipment.

3. Observe the temperature of the machine body and the bearing box. If it is within the normal range, don't pay attention to it. If the temperature continues to rise, stop immediately.

4. Listen to whether there are abnormal sounds in the equipment, such as hammer hitting the liner, any small parts falling off, etc., be sure to check in time.
Master these points, if the empty machine test run everything is normal, then you can start feeding for production. If there is any abnormality, you must contact the manufacturer in time to solve the problem. Other important equipment, such as roller press granulator, drum granulator, dryer and so on, should also ensure that the machine is normal before production.

Pre:Extruding granulator to solve uneven fertilizer nutrient

Next:Why use NPK fertilizer press granulator compared to other granulation methods

Send Inquiry

Products
Tel
contact
inquiry